Owner's Manual

Cables for adding or replacing factory amplifier.
Installation instructions for cables on Jist "C"
The "C" cable, is used when replacing or adding aftermarket amplifiers to a factory amplified system. (the cable
model
#AMP-RCA is also required) This cable plugs in between the factory radio and the dash harness that was removed
from the factory radio. The 18 pin connector then plugs into the OEM-1 . The factory system remains unchanged using
this cable.
The ADD-U NV cable is used for universal connection to the vehicle harness for vehicles not listed. (splicing
required) Audio should be at a low level when using this cable.
Use the AMP-RCA cable connected to the 16 pin connector
of the OEM-1 to connect your aftermarket amplifier. The
AMP-RCA provides 2 pair
of female RCA jacks and a remote turn on lead.
Installation instructions for the AMP-RCA cable
This cable is used when replacing or adding aftermarket amplifiers to a factory amplified system. (the appropriate
cable from list "C" is also required) The AMP-RCA cable connects to the 16 pin connector
of the OEM-1 and provides 2
pair
of female RCA jacks and a remote turn on lead for connection to your aftermarket amplifier.
Pacific Accessory Corporation
Sales 800-4 77-2267
www.Pac-audio.com
2500 E. Francis St. Ontario,
CA 91761
Tech support 866-931-8021
[e-mail]