Owner's Manual
Cables for adding
or
replacing factory amplifier.
Installation instructions for cables on list
"C"
The "C" cable, is used when replacing
or
adding aftermarket amplifiers to a factory amplified system. (the cable
model#
AMP-RCA is also required) This cable plugs
in
between the factory radio and the dash harness that was removed
from the factory radio. The 18 pin connector then plugs into the
OEM-1. The factory system remains unchanged using
this cable. The
ADD-UNV cable is used for universal connection to the vehicle harness for vehicles not listed. (splici
ng
required) Audio should be at a low level when using this cab
le.
Use the AMP-RCA cable connected to the 16 pin connector of the OEM-1
to
connect your aftermarket amplifier. The
AMP-RCA provides 2 pair of female RCA jacks and a remote tu
rn
on lead.
Installation instructions for the AMP-RCA cable
This cable is used when replacing
or
adding aftermarket amplifiers
to
a factory amplified system. (the appropriate
cable from list "C" is also required) The AMP-RCA cable connects to the 16 pin connector
of
the OEM-1 and provides 2
pair
of
female RCA jacks and a remote turn on lead for connection to your aftermarket amplifier.
Pacific Accessory Corporation
Sal
es
800-477-2267
www
. Pac-a
ud
io.com
2500
E.
Francis
St.
Ontario, CA 91761
Tech support 866-
931
-
8021
techsupport@pac-a
ud
io.com