Owner's Manual

OEM-1
REV.10-23-02
Cables for replacing Factory head unit.
Installation instructions
for
cables on
Jist
"A"
The
"A" cable,
is
used when
replacing
a factory radio. (the appropriate
cable
from
list "8" is
also
required). One
end
of
cable plugs into or connects to your new aftermarket head unit and the other end
plugs
into the 18 pin connector
of
the
OEM-1_
When using the complete
OEM-1
system the radio
will
be current protected by the
vehicle
fuse. The installer
must decide to transfer any other fuses
or
noise
filters
from the harness provided with the head uni
t.
Use the wire
I
terminal
identification chart
below
to
locate the correct power wires. The
low level
inputs are for radios up to 25watts x 4.
While
every
effort has been
made
to insure this cable was
made
to connect properly to
your
aftermarket
head
unit, changes in models
and
configurations
do
occur.
To
prevent
potential damage consult
your
stereo's owners
manual
and
check wire function (as
shown
below) with that
of
the
head
unit
you
have.
Move
any
wires that are
not
in the correct
pin
location
for
you
head
unit.
Installation instructions
for
cables on list
"B"
The
"B" cable,
is
used when
replacing
a factory radio. (the appropriate
cable
from
list "A"
is also
required).
One
end of
this
cable plugs
into the
vehicle
dash harness that was removed from the factory radio. (the AMP-UNV harness must be
spliced
into the
vehicle
harness, use the 16 pin chart
below
for wire identification) The other end plugs
into the 16 pin
connector
of
the
OEM-1.
WIRE
AND
TERMINAL /DENT/FICA
TION
Output
of
the
OEM-1,
16 pin connector (cable "B"
or
AMP-RCA
).
Looking into connector
I wire side
of
cable.
WIRE
COLOR
CIRCUIT CIRCUIT WIRE
COLOR
ORANGE
ILLUMINATION
8 16
IGNITION
SW
I
TCH
12V
RED
BLUE/WHITE
AMP
TRIGGER
7
15
BATTERY
YELLOW
BLACK GROUND 6 14
POWER
ANTENNA BLUE
PURPLE/
BLK RIGHT REAR(-) 5 13
•
RIGHT REAR (+)
PURPLE
GREEN/ BLACK
LEFT
REAR(
-)
4 12
~
LEFT REAR(+) GREEN
N/C
3
11
N/C
GRAY/BLACK
RIGHT
FRONT(-)
2
10
RIGHT
FRONT(+)
GRAY
WHITE/ BLACK
LEFT FRONT - 1
9
LEFT FRONT + WHITE
Input
of
the
OEM-1 ,
18 pin connector
(cable "A"
or
"C").
Looking into connector
I
wire side
of
cable.
WIRE
COLOR
CIRCUIT
WHITE/ BLK LEFT FRONT -
GRAY/BLK
RIGHT FRONT -
GREEN/BLK
LEFT
REAR(
-)
PURPLE/
BLK
RIGHT
REAR(
-)
BLACK
GROUND
BLUE
POWER
ANTENNA
ORANGE
ILLUMINATION/
DIMMER
BLUE/WHITE
AMP TRIGGER
RED
IGNITION/ SWITCHED
"A'
Cable
Pacific
Accessory Corporation
Sales
800-477-2267
www.Pac-audio.com
9
8
7
6
5
4
3
2
1
CIRCUIT
18
LEFT FRONT
LOW LEVEL
+
17 LEFT FRONT HIGH
LEVEL
+
16
RIGHT FRONT
LOW
LEVEL(+)
15 RIGHT FRONT HIGH
LEVEL(+)
14
•
LEFT REAR
LOW
LEVEL(+)
13
- LEFT REAR HIGH LEVEL +
12
RIGHT REAR
LOW
LEVEL(+)
11
RIGHT REAR HIGH
LEVEL
+
10
BATTERY
·s·
Cable
WIRE
COLOR
WHITE/ RED
WHITE
GRAY/RED
GRAY
GREEN/RED
GREEN
PURPLE/ RED
PURPLE
YELLOW
2500
E.
Francis
St. Ontario,
CA
91761
Tech support 866-931-8021
[e-mail]