CarConnect Bluetooth Interface Installation Manual
CarConnect Smartphone Integration Interface Installation/Owner’s Manual Table of Contents 1. Wiring Overview 2. GM Vehicles - Page 3 3. Honda/Acura Vehicles - Pages 3-4 4. Toyota/Lexus/Scion - Page 4-5 5. Connecting the Factory Satellite Radio Tuner Accessory Wire (PGHSATR) - Page 6 6. Testing & Verification - Page 7 C B A Wiring Overview Microphone Input 1 2 3 4 5 6 7 8 DIP ON USB Port iSimple a Division of AAMP of America® | Clearwater, Florida 33760 | Ph. 866-788-4237 support@isimplesolutions.
CarConnect Smartphone Integration Interface Installation/Owner’s Manual GM Vehicles GM Dipswitch Settings Escalade Non‐Nav All Other Vehicles 1. Set the dipswitches on the CarConnect interface as indicated above. 2. Carefully remove the trim panels & bolts that secure the radio into the dash cavity. Carefully pull the radio from the dash of the vehicle. This will provide access to the factory radio connectors where you will connect the CarConnect harness. 3.
CarConnect Smartphone Integration Interface Installation/Owner’s Manual Honda/Acura Vehicles (cont.) 4. Disconnect the factory 14-Pin harness (if present) from the back of the radio. 5. Prepare the CarConnect harness for installation. Depending on what factory peripherals you have in your vehicle, you may need to make changes to the red wire with bullet connectors on them. A. Vehicles equipped with factory Satellite Radio + other Peripherals (Rear Seat Entertainment, CD Changer, etc...
CarConnect Smartphone Integration Interface Installation/Owner’s Manual Toyota/Lexus/Scion Vehicles (Cont.) 1. Set the dipswitches on the CarConnect interface as indicated on Page 4. 2. Carefully remove the trim panels & bolts that secure the radio into the dash cavity. Carefully pull the radio from the dash of the vehicle. This will provide access to the factory radio connectors where you will connect the CarConnect harness. 3.
CarConnect Smartphone Integration Interface Installation/Owner’s Manual Connecting the Satellite Radio Tuner Accessory Wire **PLEASE NOTE: This only needs to be done in vehicles which have multiple factory peripherals such as Satellite Radio, Rear Seat Entertainment & a CD Changer** In some vehicles you will need to access the factory satellite radio tuner and connect the supplied PGHSATR wire to the tuner side of the accessory input wire.
CarConnect Smartphone Integration Interface Installation/Owner’s Manual Testing & Verification 1. Turn the ignition on. 2. Switch the radio to the XM or CD Changer source (depending on how you have the CarConnect configured). 3. Pair your phone with the CarConnect. The CarConnect should be discoverable after the install. If it is not, follow the procedure listed below for your mode of operation to make the CarConnect discoverable.
