Installation Guide

HONK838 Mounting Kit

Honda

2006-11 CIVIC

VEHICLE APPLICATIONS

TECH Ver. 6/16 PRINT Ver. 2/15

www.aampglobal.com www.aius.net

2500 East Francis Street Ontario, CA 91761, U.S.A.

Sales: (800) 477-2267

Intl: (727) 572-9255

Support: 888-228-5560

iHONK838

PAGE 1
www.aampglobal.com Honda 2006-11 CIVIC www.aius.net 2500 East Francis Street Ontario, CA 91761, U.S.A. Sales: (800) 477-2267 Intl: (727) 572-9255 Support: 888-228-5560 iHONK838 ©2016 AMERICAN INTERNATIONAL INDUSTRIES, INC. HONK838 Mounting Kit VEHICLE APPLICATIONS TECH Ver. 6/16 PRINT Ver.
PAGE 2
KIT PREPARATION NOTES: Fig A REMOVE ALL 4 SHADED BRACKETS 2 7
PAGE 3
NOTES: 2006-2011 HONDA CIVIC DASH DISASSEMBLY INSTRUCTIONS 1. Carefully pull forward to release then remove the trim panel below the steering column. 2. Remove the (1) Phillips screw located below the lower left edge of the Drivers instrument gauge trim bezel. 3. Lower the steering wheel all the way down. 4. Carefully unclip and pull forward the entire instrument gauge trim bezel Be careful not to scratch the radio trim fascia), disconnect all attached harnesses and remove bezel. 5.
PAGE 4
SINGLE ISO INSTALLATIONS 1. This kit is an (ISO) mounting kit only. 2. The mounting sleeve of your new radio and trim ring cannot be used when ISO mounting an aftermarket radio. Your radio must have a removable trim ring. 3. Insert pocket into lower section of kit from rear & lock into slots of mounting brackets. 4. Insert trim into the main frame. 3. Insert using 4 screws supplied mount the left and right mounting brackets to rear of main frame 5.