Installation Guide

Radio Replacement Interface with Nav Outputs
for select Audi CANbus Vehicles
With or Without Premium Audio Systems
C2R-AUDI
Pacific Accessory Corporation
Page 2
© 2018 AAMP Global. All rights reserved. PAC is a Power Brand of AAMP Global.
PAC-audio.com
Rev: V3
Date: 060118
Installation Steps
1. Remove the factory radio.
2. Make all connections between the aftermarket radio’s harness and the supplied vehicle harness, as described in the wiring
connections chart on page 1.
3. Be sure to connect the Blue / White wire even if the vehicle is not equipped with an amplier.
4. Connect the C2R-CHY4 harness to the vehicle’s harness.
5. If retaining SWC, then follow the steps in the next section “SWC Output Connector”
SWC Output Connector
1. The harness has a SWC output connector. For ease of installation,
all necessary connections for an SWI have been made for you. Both
loops should remain intact.
2. When using this SWC output connector with the SWI-RC, the SWC
interface must be programmed for version 2 (refer to SWC interface
programming instructions for exact programming sequence and
button assignment order).
3. When using this SWC output connector with an SWI-CP2, you can
either program the SWC interface with a PC, or set the DIP switches
according to the PC app.
Connect to Radio
Specific SWC
Interface
PAC SWC
Interface
Illustration / Schematic
C2R-AUDI
9
1
2 3 4 5 6
7 8
10 11
91
Wiring SWC Connection
Aftermarket
Radio
Connections
Vehicle
Connection
SWC
Connection
Connect to Radio
Specific SWC
Interface
PAC SWC
Interface
Testing and Verication
1. Turn the ignition on. The LED on the interface will turn on and the +12v accessory wire will turn on.
2. Turn on the radio and check balance and fade.
3. Verify that all SWC are functioning properly.
4. Turn off vehicle and remove key. RAP will be active and will keep the radio on for 10 minutes or until the driver’s door is opened.
5. The LED and radio will turn off when RAP turns off or the driver’s door is opened.
Technical Support
Technical Support
[e-mail]
866-931-8021