Installation Guide
OE Radio
APH-FD01 Installation Diagram
AmpPRO Harness allows you to use your factory speaker wiring without cutting it.
Aftermarket Amplier
OE speaker
locations
OE speaker wiring
Output
side
Input
side
Aftermarket Subwoofers
in aftermarket enclosure
(Typical installation)
Green represents
Factory wiring
APH-FD01 Harness 16-pin BLUE harness.
This harness is only used if
you are adding an
aftermarket amplier and replacing the subwoofer
in the factory (OE) subwoofer location
and want to use the OE wiring.
(Not typical installation)
APH-FD01 Harness 16-pin GREY harness.
This harness is used for passing aftermarket amplied audio
to the cabin speakers, using the factory (OE) wiring.
(Typical instllation)
Cut o Load resistors and connect “pass-through”
wires from Grey connector to Grey connector
for any cabin speakers to remain powered by the
factory amplier. (not the aftermarket amp)
RCA
or
TOSLINK
cable
Both Sold Separately
OE sub wiring
APH-FD01
Connect to Amplier, only if you
are amplifying the OE Sub enclosure
AmpPRO
Module
OE Subwoofer
location
OE Amplier
Input Output