User Manual

2
Santa Ana, CA 92705
[e-mail] • www.pac-audio.com
Installation Diagram
Factory Radio (rear view)
16 Pin Data Port
Power / Speaker
Connector
Line Input
Adjustment
(Rotate Counter
Clockwise from
Min to Max)
Factory 16-pin
Connector
(if present)
Plug in Auxiliary
Device into
RCA Connectors
Black/Green
(Ground)
Gray/Violet
(+12V Constant)
*NOTE: If AAI-FD4 is not recognized by radio:
Turn off ignition and remove key, making sure radio shuts off.
Disconnect the factory 16-pin connector from the AAI-FD4 vehicle harness.
Turn on ignition and radio.
Press AUX button and verify that AAI-FD4 is recognized.
Reconnect factory 16-pin connector while radio is on AUX mode.
Leave radio on for at least 1 minute.