Manual

5
email - support@aampglobal.com (US)
tel - 1-800-477-2267 (East Coast) - 1-888-883-2790 (West Coast)
email - technical.eu@aampglobal.com (Europe)
Installation Guide
4
Installation Guide
email - support@aampglobal.com (US)
tel - 1-800-477-2267 (East Coast) - 1-888-883-2790 (West Coast)
email - technical.eu@aampglobal.com (Europe)
Operating Instructions (continued)
Wiring Diagram
PMM-7333-PL
7.3” Factory Mount Mirror Monitor
with 3 Video Inputs, 3 Triggers and
Adjustable Parking Lines
PMM-7333-PL
7.3” Factory Mount Mirror Monitor
with 3 Video Inputs, 3 Triggers and
Adjustable Parking Lines
All other functions are controlled by the supplied remote.
You can access all adjustable parameter by pressing the MENU button on
the remote.
Adjustable parameters are as follows.
Brightness: Adjust the brightness of the screen.
Color: Adjust the color of the screen.
Contrast: Adjust the contrast of the screen.
Scale: This turns the parking guide line for the reverse input on or off.
Start Logo: This enables or disables the boot-up logo when the screen is
powered up.
Preset: This resets all values to default.
You are also able to adjust the on-screen position of the parking lines to
ensure accurate positioning for your particular vehicle. To enter this setting
press the center button on the remote D pad (this menu is only accessible
when the reverse image is being displayed).
Pressing the center button will toggle between the left (XL) guideline and
right (XR).
Use the 4way D-pad to adjust the physical position of the guidelines
independently.
The buttons to the left and right of the MODE button will adjust the angle
of the guidelines.
To set the lines accurately place some 2” wide tape at the rear of the
vehicle parallel to each other. The tape should be about 12ft long and 6”
outside the maximum width of the vehicle (please see image on the next
page). It must be visible on the display when the vehicle is in reverse.
You can then set the guidelines to
match the tape.
Press the center button again to
exit the guideline setup screen.
+12V Ignition
GND
Video 1
Reverse
Video 2
(Black)
(Red)
Trigger 2
Trigger 1
(Purple)
(White)
Reverse Trigger
(Green)
FILTER &
FUSE BOX
IN
OUT
2” Wide Tape
12ft
6”