User Manual

ASSEMBLY INSTRUCTIONS:
1. Assemble booth per instructions on the back of this
sheet.
2. Place spray booth on a sturdy stable surface larger than
its base (20" x 22") and capable of supporting 30lbs. or more.
3. The plenum chamber screen is factory installed from the
front of the spray booth (Illustration C).
4. The CHAR-8" Carbon filter (black) and then the AG-8"
paint filter (White) are factory installed into the plenum
chamber so they are secured by the outer perimeter of the
inlet to the plenum chamber (Illustration A).
CAUTIONS:
1. Do not use this equipment in explosive atmospheres or
near sparks, heat or open flame.
2. Plug the unit into 3 hole properly grounded outlet.
Always un-plug the unit before assembly or disassembly of
components or changing filters.
3. Do not operate the unit near running water or a wet
surface. Avoid any type of exposure of the motor to direct
moisture.
4. Protect the power cable from coming into contact with
sharp edges, oil, grease, hot surfaces or chemicals.
5. Wiping or cleaning rags and other flammable waste
materials must not be used near the motor when operating.
Waste materials must be disposed of in a proper fashion.
6. Do not remove the Fan Outlet Grill. The fan blade is
sharp and can cause serious injury if contacted while
running. Use Fan Outlet Adapter for exhausting to the
outside.
7. This unit is intended to remove larger particles from the
air when painting small objects such as models and pottery.
It will not remove all hazardous material from the air so
caution should be taken when spraying materials that have
strong vapors or harmful chemicals. When required, wear
protective paint and vapor mask and vent the unit to
the outside atmosphere using 4'' dryer duct. Change
booth filters frequently.
INSTRUCTIONS AND PARTS LIST HSSB-22-16-8/31/2011
Supersedes Instructions and Parts List HSSB-22-16-5/18/2011
Printed in the U.S.A.
WARNING: Spray materials may be harmful if inhaled or allowed
to come into contact with the skin or eyes. Consult the product
label and Material Safety Data Sheet supplied for the spray
material. Follow all safety precautions. Use HSSB to create a
Well Ventilated Area to remove fumes, dust or overspray.
Exhaust to the outside. Change filters frequently and dispose of in
a safe manner. Fan Outlet Grills Must Be Installed At All
Times When Not Using Dryer Hose Adapter. Before spraying
make sure air is blowing out of booth as shown below.
4" Dryer Hose Adapter for Outside Exhaust Connection.
Secure Adapter using two vertical screw holes on Blower
Assembly - horizontal screw holes hold the Fan - do not remove.
Paasche Airbrush Company
4311 North Normandy Avenue
Chicago, IL 60634-1395
Phone: [phone] • Fax: [phone]
Website: www.paascheairbrush.com
E-Mail: [e-mail]
HSSB-22-16 Hobby-Shop Spray Booth
OPERATING INSTRUCTIONS AND REPLACEMENT PARTS
(235 CFM, 115 Volts, 60 Cycle, .43 AMPS)