Installation Manual Manual

ULTRA MAGNUM SERVO ROLL FEED 2 /14/2003
8
1. `Put the Ultra Magnum control into “MANUAL MODE”. Record the present settings of the Feed Cam, Reset Cam,
and Pilot Release Cam into a job set-up record sheet for future reference to the job.
2. Refer to the Thickness Setting Chart shown above. Adjust the material thickness dial for the proper material
thickness. Refer to the example in the following drawing for proper setting.
3. Open the feed rolls with the “OPEN/CLOSE” switch on the jog pendant. Insert the material and close the feed rolls.