Manual

ULTRA EDGE SERVO ROLL FEED 2/09/2002
6
2.1 “OPER” KEY
“OPER” key controls appearance of four screens: STATUS screen and three OPERATOR screens.
STATUS screen shows
:
P / A I n d u s t r ie s
M a n u al M o d e
3 0 / C o n t. R u n
P r e s s a M o d e Ke y
• Current mode of the feed
• Batch count, current and commanded
OPERATOR screens show and allow editing the following parameters:
L e n gt h 1 . 0 0 0
C o u nt C o nt . R u N
L e n gt h A d j u s t m en t <
P r e ss O P E R f o r n e x t
Length is a distance in inches (or millimeters) of the “Feed Length”. It is a numeric entry with a range of 0 to the
Maximum Length.
Count is the number of feed indexes that should be performed. It is a numeric entry with a range of 0 to 9999999.
Entering “0” will result in a continuous run.
Length Adjustment is not a parameter but a feature that allows micro adjusting of the Length parameter. The
Length parameter can be micro adjusted even while feed is feeding material.
S p e ed 7 2
A c c el 4 0 0 . 0
D e c el 4 0 0 . 0
P r e ss O P E R f o r n e x t