Manual

3.4 EDGE MOUNTING HOLES
STEP #1:
Press the amber ‘POWER ON’ push-button. The
button will illuminate and the data input display
will be visible:
☞
STEP #2:
Press any key on the terminal, the display will show:
☞
STEP #3:
The ‘POWER ON’ push-button has a ‘FAULT
RESET’ function built into the button. The feed
may now be jogged forward by pressing the ‘
JOG
FORWARD
’ button, or jogged in reverse by
pressing the ‘
JOG REVERSE’ button.
The Edge Servo Roll Feed has six viewable
screens. Only the first operator screen (shown
above) will be operator editable/programmable.
This screen displays the length, count, and speed
parameters. These parameters may only be changed
while the program is stopped (indicated by lack
of ‘
CYCLE START’ or set up light). The other
viewable screens are shown on the following page.
These five other screens will be viewable at all times,
but are "locked" out of programming via run/prog
switch located on the electrical panel inside the
electrical enclosure. The factory set parameter values
for the Edge Servo Roll Feed are printed on the
operator panel below the operator terminal.
EDGE SRF100-600
SRF-400/
DIMENSION SRF-100 SRF-125 SRF-200 SRF-300 500/600
A 1.18 1.97 1.97 1.97 1.97
B 1.97 3.15 3.94 3.94 3.94
C 3.94 6.30 7.87 7.87 7.87
D ––––5.91
TAP M14 M16 M16 M16 M16
E MIN. 2.2 2.4 2.4 2.4 2.4
PASS LINE +2 +2.4 +2.4 +2.4 +2.4
ADJUSTMENT -0.0 -0.0 -0.0 -0.0 -0.0
EDGE MOUNTING HOLES
for drawing 17147-03
SRF-400/
DIMENSION SRF-100 SRF-125 SRF-200 SRF-300 500/600
A 30505050 50
B 50 80 100 100 100
C 100 160 200 200 200
D ––––150
TAP M14 M16 M16 M16 M16
E MIN. 55 60 60 60 60
PASS LINE +50 +60 +60 +60 +60
ADJUSTMENT -00.0 -00.0 -00.0 -00.0 -00.0
4
CENTER LINE OF RAM
D
C
D
B
E
A
TAP X 1” (25mm) DEEP
BOLSTER
BOLSTER
DRAWING 17147-03
ADJUSTABLE
CAM BAR
TYPICAL MOUNTING ON GAP FRAME PRESS
PASS LINE
ADJUSTMENT
PASS LINE
PASS LINE
E REF
A REF
INCHES
METRIC
Figure 2.
4. PROGRAMMING THE EDGE
SERVO FEED SYSTEM
IMPORTANT !
Before turning the system on for the first time,
verify that the main input voltage is correct
(120 VAC single phase) and inspect all
connections for tightness, shorts, etc.
P/A INDUSTRIES
SERVO ROLL FEED
VERSION 1.00
HIT KEY TO CONT__
LENGTH 00008.000
COUNT 100000
SPEED 0062/SEC