User guide

ULTRA EDGE SERVO ROLL FEED 2/14/2003
22
NOTE: The following six screens are part of the optional PLS package and displayed only if the corresponding
software is loaded.
Press “TOOLS” to open the next screen. Position cursor next to desired parameter, enter new value, and then press
“ENTER” key.
T o o l# 1 P o s : 3 5 4
F e e dC a m O n 2 6 0
F e e dC a m O f f 9 0
T O O LS - n e x t B K S P - P r e v
Press “TOOLS” to open the next screen. Position cursor next to desired parameter, enter new value, and press
“ENTER” key.
T o o l# 1 P o s : 3 5 4
R e s et C a m O n 1 8 0
R e s et C a m O f f 2 0 0
T O O LS - n e x t B K S P - P r e v
Press “TOOLS” to open the next screen. Position cursor next to desired parameter, enter new value, and press
“ENTER” key.
T o o l# 1 P o s : 3 5 4
P i l ot R e l O n 1 2 5
P i l ot R e l O f f 2 4 0
T O O LS - n e x t B K S P - P r e v
Press “TOOLS” to open the next screen. Position cursor next to desired parameter; enter new value, and press
“ENTER” key.
T o o l# 1 P o s : 3 5 4
A u x 1 O n 0
A u X 1 O f f 1 2 0
T O O LS - n e x t B K S P - P r e v
Press “TOOLS” to open the next screen. Position cursor next to desired parameter, enter new value, and press
“ENTER” key.
T o o l# 1 P o s : 3 5 4
A u x 2 O n 12 0
A u X 2 O f f 2 4 0
T O O LS - n e x t B K S P - P r e v
Press “TOOLS” to open the next screen. Position cursor next to desired parameter, enter new value, and press
“ENTER” key.
T o o l# 1 P o s : 3 5 4
A u x 3 O n 24 0
A u X 3 O f f 0
T O O LS - n e x t B K S P - P r e v