User guide

ULTRA EDGE SERVO ROLL FEED 2/14/2003
21
T oo l # 1 S a v e d
NOTE: Make sure that the PROGRAMMING “LOCKED / UNLOCKED” key switch is in “Unlocked”
position. If the current screen is one of the tool editing screens (they all have message on the last line “ Press
TOOLS for next”), press the “OPER” key to exit tool editing.
Press “TOOLS” key, position the pointer next to EDIT TOOL command and press the “ENTER” key.
E d i t T o o l <
A c t iv a t e T o o l
C r e at e N e w
P r e ss T O O L S t o E x i t
Enter desired tool number or select it from the tool list using “↑” and “↓” keys and press the “ENTER” key again.
E d i t T o o l #
A r r ow k e y s t o s c r o l l
P r e ss T O O L S t o e x i t
E d i t T o o l # 1
A r r ow k e y s t o s c r o l l
P r e ss T O O L S t o e x i t
Position cursor next to desired parameter, enter new value, and press the “ENTER” key.
T o o l# 1
L e n gt h 2 0 . 0 0 0
C o u nt C o n t . R u n
P r e ss T O O L S f o r n e x t
Press “TOOLS” key to open next screen. Position cursor next to desired parameter, enter new value, and press the
“ENTER” key.
T o o l# 1
S p e ed 7 2
D w e ll 0
T O O LS - n e x t B K S P - P r e v
Press “TOOLS” key to open next screen. Position cursor next to desired parameter, enter new value, and press the
“ENTER” key.
T o o l# 1
A c c el 4 0 0 . 0
D e c el 4 0 0 . 0
T O O LS - n e x t B K S P - P r e v