User guide

ULTRA EDGE SERVO ROLL FEED 2/14/2003
20
T o o l# 1 P o s : 3 5 4
F e e dC a m O n 2 6 0
F e e dC a m O f f 9 0
T O O LS - n e x t B K S P - P r e v
Press “TOOLS” to open the next screen. Position cursor next to desired parameter, enter new value, and press
“ENTER” key.
T o o l# 1 P o s : 3 5 4
R e s et C a m O n 1 8 0
R e s et C a m O f f 2 0 0
T O O LS - n e x t B K S P - P r e v
Press “TOOLS” to open the next screen. Position cursor next to desired parameter, enter new value, and press
“ENTER” key
.
T o o l# 1 P o s : 3 5 4
P i l ot R e l O n 1 2 5
P i l ot R e l O f f 2 4 0
T O O LS - n e x t B K S P - P r e v
Press “TOOLS” to open the next screen. Position cursor next to desired parameter; enter new value, and press
“ENTER” key.
T o o l# 1 P o s : 3 5 4
A u x 1 O n 0
A u X 1 O f f 1 2 0
T O O LS - n e x t B K S P - P r e v
Press “TOOLS” to open the next screen. Position cursor next to desired parameter, enter new value, and press
“ENTER” key.
T o o l# 1 P o s : 3 5 4
A u x 2 O n 12 0
A u X 2 O f f 2 4 0
T O O LS - n e x t B K S P - P r e v
Press “TOOLS” to open the next screen. Position cursor next to desired parameter, enter new value, and press
“ENTER” key.
T o o l# 1 P o s : 3 5 4
A u x 3 O n 24 0
A u X 3 O f f 0
T O O LS - n e x t B K S P - P r e v
Press “TOOLS” key to open next screen. To save changes choose SAVE command and press the “ENTER” key.
T o o l#
S a v e <
S a v e a s
T O O LS - n e x t B K S P - P r e v