Installation Manual User guide

ULTRA ADVANTAGE SERVO ROLL FEED 6/ 3/2002
3
1 INSTALLATION
1.1 MECHANICAL INSTALLATION
The Servo Pilot Release assembly comes fully installed on the Servo Roll Feed so that no installation tasks are
required. The Ultra Advantage Servo Roll Feed is supplied with an adjustable mounting bracket. The feed should be
securely mounted to the press frame. (A transition bracket is sometimes required in certain applications.) The feed
should be centered, square, and perpendicular to the pass line of the press. It should be mounted at a height that will
accommodate the appropriate die sets. The feed has a pass line height adjustment of ±1.2 inches. (Note: The centerline
of the Feeder is NOT the centerline of the rolls.) Refer to FIGURE 1 for dimensions.
The feeder may be used to push or pull strip stock through the die.
FIGURE 1