User Manual

ULTRA ADVANTAGE SERVO ROLL FEED 2/10/2003

3 PROGRAMMING THE ULTRA ADVANTAGE SERVO ROLL FEED

SYSTEM - OVERVIEW

NOTE: Before attempting any programming, make sure that the “PROGRAMMING LOCKED / UNLOCKED”

key switch is in the “Unlocked” position.

NOTE: After power shutdown, WAIT for 10 seconds before powering up the Feed.

Turn on the main power disconnect switch. This applies power to the control power supply. Press the green Power On

push-button. The button will illuminate and the OPERATOR terminal display will be visible.

Wait for the IN POSITION light to illuminate.

Press any key to begin.

P / A I n d u s t r i e s

R e a l l y C o o l F e e d

V e r s i o n 1 . 0 0 s t d

H i t a n y k e y t o c o n t .

NOTE: The OPERATOR terminal has three mode keys, they are:

● “OPER”

● “TOOLS”

● “SETUP”

NOTE: ▓ The flashing cursor is waiting for the value to be entered.

NOTE: < The pointer prompts to press the “ENTER” key.

NOTE: To confirm any value, press “ENTER”.