User Manual

ULTRA ADVANTAGE SERVO ROLL FEED 2/10/2003

RECEIVING INSPECTION

BEFORE REMOVING UNIT FROM ITS PACKAGING, CHECK FOR VISUAL DAMAGE,

ESPECIALLY IF CRATE, SKID, OR CARTON HAS BEEN DAMAGED IN TRANSIT. ANY

DAMAGE CAUSED IN SHIPMENT SHOULD BE IMMEDIATELY REPORTED TO THE CARRIER.

IF UNIT APPEARS IN SATISFACTORY CONDITION, REMOVE ALL PACKING AND WIPE RUST

PREVENTIVE FROM ROLLERS WITH MILD SOLVENT.

1 INTRODUCTION

IMPORTANT

Before turning the system on for the first time, verify that installation has been completed according to the

Installation manual and the main input voltage is 220 VAC, single phase.

The P/A Industries Ultra Advantage Servo Roll Feed with Servo Pilot Release is a state of the art AC Servo feed, which

simplifies Operator adjustments to feed parameters. These Operator adjustments are entered into the control memory

through the keypad. With the use of programmable limit switches, the press signals the feeder when to begin moving the

strip, when the feed pitch must be completed, when the press has completed its down stroke, and when to open the rolls

for piloting.

The mechanical simplicity, accuracy, and ease of use of the Ultra Advantage Servo Roll Feed will help to improve your

quality and production for years to come.

2 THEORY OF OPERATION

2.1 MECHANICAL ASSEMBLY

Mechanical assembly consists of:

1) Adjustment/Mounting bracket

2) Feeder

3) Feed Servomotor with Gear Reducer

4) Release Servomotor with Gear Reducer

5) PLS – Programmable Limit Switch

2.2 ELECTRICAL CONTROL ENCLOSURE ASSEMBLY

Electrical control enclosure consists of:

1) Control switches/buttons/relays

2) Power supply, 24 VDC/5 VDC

3) Feed Servo drive – Master drive

4) Release Servo drive – Slave drive

5) Data entry terminal

6) Cabling

7) Jog Pendant