User Manual

ULTRA ADVANTAGE SERVO ROLL FEED 2/10/2003
18
Press “TOOLS” to open the next screen. Position cursor next to desired parameter; enter new value, and press “ENTER”
key.
T o o l # 1 P o s : 3 5 4
A u x 1 O n 0
A u X 1 O f f 1 2 0
T O O L S - n e x t B K S P - P r e v
Press “TOOLS” to open the next screen. Position cursor next to desired parameter, enter new value, and press “ENTER”
key.
T o o l # 1 P o s : 3 5 4
A u x 2 O n 1 2 0
A u X 2 O f f 2 4 0
T O O L S - n e x t B K S P - P r e v
Press “TOOLS” to open the next screen. Position cursor next to desired parameter, enter new value, and press “ENTER”
key.
T o o l # 1 P o s : 3 5 4
A u x 3 O n 2 4 0
A u X 3 O f f 0
T O O L S - n e x t B K S P - P r e v
Press “TOOLS” key to open next screen. To save changes, choose the SAVE command and press the “ENTER” key.
T o o l #
S a v e <
S a v e a s
T O O L S - n e x t B K S P - P r e v
T o o l # 1 S a v e d
4.2 HOW TO EDIT AN EXISTING TOOL
NOTE: Make sure that the PROGRAMMING “LOCKED / UNLOCKED” key switch is in “Unlocked”
position and OPERATOR screen is displayed. If the current screen is not OPERATOR one then press the
“OPER” key to bring it up.
Press “TOOLS” key, position the pointer next to EDIT TOOL command and press the “ENTER” key.
E d i t T o o l <
A c t i v a t e T o o l
C r e a t e N e w
P r e s s T O O L S t o E x i t