User Manual

ULTRA ADVANTAGE SERVO ROLL FEED 2/10/2003

Release Ange is an angle of the feed release shaft rotation. It is proportional to the roll lifting distance. The rolls are open

with no material at about 10

, but some trial and error effort is normal to find the minimum lifting distance (minimum

opening angle) for the certain application. It is a numeric entry with a range of 0 to 45degrees.

Release Speed is a speed of the feed release shaft rotation. It is a numeric entry with a range of 0 to 9999 degree/sec.

Normally set 9999 degree/sec.

Release Accel is an acceleration/deceleration rate of the feed release shaft rotation. It is a numeric entry with a range of 0

to 400000 degree/sec

. Normally set 400000 degree/sec

R e l S c a l e 1 1 6 5 0 . 8

R e l H o m e O f f s e t 3 . 0

R e l I n P o s i t i o n 0 . 5 0

S E T U P - E x i t B K S P - P r e v

Rel Scale is the release encoder scaling parameter used to define the number of encoder counts/degree. It is a numeric

entry with a value of 11650.8 conunts/degree.

Rel HomeOffset is a difference in degrees between release encoder zero position and the feed release shaft position when

the rolls are fully closed. It is a numeric value, with a range of 0 to 45.

Rel InPosition is a tolerance window in degrees around the position of the fully open rolls. This is used to verify the

release accuracy is within acceptable limits before continuing onto the next function. It is a numeric entry with a range of

0 to 5 degrees. Normally set 0.5 inch.

NOTE: To exit setup editing at any time, press the “OPER” key. Changes will be saved.

4 HOW TO …

4.1 HOW TO CREATE A NEW TOOL

NOTE: Make sure that the PROGRAMMING “LOCKED / UNLOCKED” key switch is in “Unlocked”

position and OPERATOR screen is displayed. If the current screen is not OPERATOR one then press the

“OPER” key to bring it up.

Press the “TOOLS” key.

Position the pointer next to Create new tool command and press the “ENTER” key.

E d i t T o o l

A c t i v a t e T o o l

C r e a t e N e w <

P r e s s T O O L S t o E x i t

Enter new tool number and press the “ENTER” key again.

C r e a t e T o o l #

P r e s s T O O L S t o E x i t

C r e a t e # 1