Owner manual

ULTRA ADVANTAGE SERVO ROLL FEED 2/14/2003
8
3.1 “OPER” KEY
“OPER” key controls appearance of two screens: STATUS screen and OPERATOR screen.
STATUS screen shows:
T o o l # 1 P o s : 1 8 2
M a n u a l M o d e
3 0 / C o n t . R u n
P r e s s a M o d e K e y
• Active tool number. In case there is no active tool “No Tool!” message is displayed instead
• Current press position in degrees. Available only on PLS model
• Current mode of the feed
• Batch count, current and commanded
NOTE: When the feed is turned into Auto mode it displays current press speed (in strokes per minute) instead of
current press position.
T o o l # 1 S p d : 3 8 4
A u t o M o d e
3 0 / C o n t . R u n
P r e s s a M o d e K e y
OPERATOR screen shows and allows editing the following parameters:
L e n g t h 1 . 0 0 0
C o u n t C o n t . R u n
L e n g t h A d j u s t m e n t <
P r e s s O P E R t o e x i t
• Length
• Batch count command
• Length micro adjustment
Every time the “OPER” key is pressed it toggles between the STATUS screen and the OPERATOR screen.
3.2 “TOOLS” KEY
“TOOLS” key controls appearance of TOOL STORAGE screens. Press the “TOOLS” key to open the first screen.
This allows the Operator to chose a Tool Storage operation: “Edit Tool”, “Activate Tool”, or “Create New Tool”.
E d i t T o o l
A c t i v a t e T o o l <
C r e a t e N e w
P r e s s T O O L S t o e x i t