Owner manual

ULTRA ADVANTAGE SERVO ROLL FEED 2/14/2003
28
T o o l # P o s : 0
M a n u a l M o d e
3 0 / C o n t . R u n
P r e s s a M o d e K e y
At this point the press and PLS are synchronized and you can start setting cam On/Off parameters.
4.11 HOW TO SET CAM “ON”/“OFF” PARAMETER
Open the screen that displays desired cam settings, jog the press to position where cam should turn on, read the exact
value of the press current position and enter this value for Cam On parameter.
T o o l # 1 P o s : 3 5 4
F e e d C a m O n 2 6 0
F e e d C a m O f f 9 0
T O O L S - n e x t B K S P - P r e v
Follow the same procedure to set Cam Off parameter.
5 OPERATING THE ULTRA ADVANTAGE SERVO FEED
5.1 PROGRAMMING
There is no need to program anything if the “Tool Storage” is properly set up. It is only a matter of activating the needed
tool, although the OPERATOR screen allows the Operator to edit two basic parameters.
OPERATOR screen is the only one that is Operator editable. This screen displays Length, Count, and Length
Adjustment. Length and Count can be changed only when cycling is stopped, although Length can be adjusted by
using the LENGTH ADJUSTMENT command even while the feed is running.
When Length and Count are edited or adjusted from OPERATOR screen, they override the stored tool Length and
Count and will be active until current tool is reactivated or another tool is activated.
Activate tool is the only command that is Operator accessible and can be executed only when the feed is not cycling.
5.2 PRIORITY MODE
The Ultra Advantage Servo Roll Feed has two modes of automatic cycle starting. The choice can be made between
“Press – Before – Feed” (“PBF”) and “Feed – Before – Press” (“FBP”) operating mode.
When “PBF” mode is selected and the Cycle Start button is pressed on the control panel, the feeder causes the “Auto”
and “Permit Press” relays to turn on thus enabling the start of continuous cycling on the press.
When “FBP” is selected and Cycle Start button is pressed on the feed control, the material/strip will be fed forward
before the press is started. The Operator may verify that the strip is in position before starting the press.
The Ultra Advantage Servo Roll Feed will now follow the press until it is stopped by the Operator, counter, emergency
stop, or feed error.
5.3 “JTL” (JOG TO LENGTH) MODE
“JTL” mode is used primarily during the threading of the strip through the die. This mode allows the Jog – To – “Feed
Length” operations to be performed. While in the “JTL” mode, the strip may be moved using the remote Jog Pendant.
If the “Jog Forward” is stopped before the “Feed Length” is reached, then either the “Jog Forward” or the “Jog
Reverse” Operator buttons will work. The “Jog Reverse” will not allow the strip to go backwards beyond the initial
“Feed Length” starting point.