User Manual
P.G. TM0040AE
1-2
1.1.4.3
- If a FAULT condition is detected the unit transmits a low frequency identification
code along the cable center conductor. The burst transmission is repeated at
approximately 80 second intervals, while a fault condition exists.
1.1.4.4
- If a NORMAL condition exists in the amplifier a low frequency OK identification
code will be transmitted on the cable at intervals of approximately 80 minutes.
1.1.4.5
– The unit has an adjustable attenuator in each band to allow operation at reduced
gain. The attenuator is settable in 1 dB steps up to 15 dB either manually or by using an
optional AUTOSET control board.