User's Manual

P.G. TM0032FE
3 - 3
Local powered unit (P/N 001-0211-003):
1. Locate a suitable mounting location, allow a clearance of at least 5 inches (13 cm)
to route mating cable and connectors to the unit. Drill four pilot holes on 7.63 x 5
inch centers for No.10 fasteners.
2. Mount the amplifier ensuring there is good air circulation around the amplifier.
3. Connect J2, "BASE" to the cable leading to the base transmitter.
4. Connect J1, "ANTENNA" to the cable leading to the distribution antenna(s).
5. If the cellular and/or PCS attenuator need setting then remove the cover and refer
to Section 4.2. Replace the cover after setting the attenuators.
This completes the installation.