User's Manual

P.G. TM0051
1-3
NOTE IMPORTANT RATING INFORMATION
Manufacturer’s rated output power of this equipment is for single
carrier operation. For situations when multiple carrier signals are
present, the rating would have to be reduced as per Table 1-2,
especially where the output signal is re-radiated and can cause
interference to adjacent band users. This output power reduction is
to be achieved by reduction of input power or by gain reduction and
not by an attenuator at the output of the device.
TABLE 1-2
Rated Power Output for Linear Operation
The total composite output power in multiple tone or wideband signals shall NOT exceed the
following level or else it may result in improper operation of the device and cause
interference. The composite output power rating is defined as the total average RMS output
power of all inband signals. The unit should be operated at or below this level to ensure
linear operation with low distortion. This holds true for any number of carriers with total
average power adding up to the composite output power rating listed in the table below.
Parameter Specification
Base Transmit (Downlink) Power: +16 dBm
Portable Transmit (Uplink) Power: +16 dBm
NOTE: See NOTE in Section 3.3.