Installation and Operation Manual

November 1999
M68334 Rev. A Tel-Link PMP - Remote Terminal Installation & Maintenance Manual 10-5
10.3.4.2T1-Frame Relay ASM
STEP 1. Provision a CBR connection with the appropriate VPI/VCI for 1.544 mbps CAS
between the T1-Frame Relay ASM and the ATM switch.
STEP 2. Connect the Frame Relay test set #1 to Port 1 of the Frame Relay ASM.
STEP 3. Connect the Frame Relay test set #2 to a T1/FR port on the ATM switch.
STEP 4. Configure the Remote Terminal ATM port under test for internal loopback.
STEP 5. Configure each Frame Relay test set to generate “keep alive” messages at a rate of 2
per minute.
STEP 6. Reset the test set and allow the test to run for 30 minutes.
STEP 7. Record the following performance parameters.
• FCS Errors
• LMI Time-outs
• LIM Errors
• LMI Messages
• PVC Status
10.3.4.310 BaseT ASM
STEP 1. Provision the 10 BaseT ASM with the appropriate VPI/VCI and IP address.
STEP 2. Configure the PC with LAN Analyzer software loaded with the appropriate IP address.
STEP 3. Generate Ethernet Packets (pings) from the PC to Destination IP. All pings should have
a response with a mean response time of <10 ms.