Manualshelf

Installation and Operation Manual

ManualsBrandsP Com ManualsElectronicsPMP-04-280
51525354555657585960
November 1999
10-4 M68334 Rev. A Tel-Link PMP - Remote Terminal Installation & Maintenance Manual
STEP 3. Reconnect the IF Cable to the Remote IDU and verify the following LED state
occurred:
10.3.2 Power-up Restoration
The following steps will ensure the PMP equipment will restore back to an operational state with the inter-
ruption of power:
STEP 1. Connect an ATM Test Set to the ASM. Place an ATM Port of the Remote IDU into a
loopback mode and the ATM Test Set will generate ATM packets.
STEP 2. Allow the system to stabilize into an operational state and turn the power off to the
Remote IDU. The ATM Test Set should be displaying bit/packet errors.
STEP 3. Reapply power to the Remote IDU. After approximately one minute, the bit/packet
errors displayed on the ATM Test Set should halt.
10.3.3 Network Monitoring
The following steps will demonstrate messaging between a Sector and Remote Terminal:
STEP 1. Allow the system to stabilize into an operational state.
STEP 2. From the Sector Terminal using the LSM with the proper Site ID selected, initiate a Get
All command on the Remote Controller Section. The Remote Controller Chassis Win-
dow should refresh with configuration parameters.
STEP 3. initiate a Get All command on the ODU Section. The ODU Chassis Window should
refresh with configuration parameters.
10.3.4 Over The Air System Integration
The following procedures will demonstrate the over-the-air system integration of the PMP equipment will
not significantly degrade bit error rate performance.
10.3.4.1T1-CES ASM
STEP 1. Provision a CBR connection with the appropriate VPI/VCI for 1.544 mbps CAS
between the T1-CES ASM and the ATM switch.
STEP 2. Generate traffic of the CBR (1.544 Mbps) from the Remote Terminal to a test set con-
nected to the ATM Switch.
STEP 3. Verify the equipment can handle the traffic with no lost cells and conduct a Bit Error
Rate Test for 15 minutes. The BER test set should display a performance of zero bit
errors (BER performance <1E-9).
BOARD GREEN LEDs RED LEDs
Remote IDU Blinking Off