Installation and Operation Manual

November 1999
8-4 M68334 Rev. A Tel-Link PMP - Remote Terminal Installation & Maintenance Manual
Figure 8-4 - ATM Service Module DC Input (Rear View)
8.2.6 ASM to IDU Wiring
The ATM Service Module is connected to the IDU via a UTP-5 cable with RJ-45 connectors. The length of
the cable should be sufficient to allow a small service loop near each end but should not exceed 20 feet (6
meters) in length. Connect one end of the cable to the ATM STP-1 Interface Port of the ASM. Connect the
other end of the cable to the appropriate ATM Service Module Interface Port of the IDU (refer to Figure 8-5).
Figure 8-5 - ASM to Remote ATM IDU Wiring
Chassis Ground Stud
Ethernet Interface Port
User Interface Port
ATM STP-1
Interface Port
DC Input Interface Port