Installation and Operation Manual

November 1999
M68334 Rev. A Tel-Link PMP - Remote Terminal Installation & Maintenance Manual 6-5
Figure 6-6 - Final Assembly
STEP 9. Attach the ODU to the back side of the Antenna Assembly by mating the antenna
waveguide to the ODU orifice, ensuring the IFL Port is in the lower right hand position.
This will place the ODU in a vertical transmit polarity. Snap into place using the retain-
ing clips (refer to Figure 6-7). Final polarization will occur during commissioning.
Figure 6-7 - Attaching ODU to Antenna Assembly
Azimuth
Elevation
Adjustments
ODU
Retaining
Clips
Waveguide
Protection
Cap
IFL
Port
Connection
Waveguide
Orifice
Antenna
Assembly
Retaining
Clips