Installation and Operation Manual

November 1999

6-4 M68334 Rev. A Tel-Link PMP - Remote Terminal Installation & Maintenance Manual

STEP 6. Rotate the Elevation Adjustment Rod and position the Antenna so its elevation is

coarsely aligned with the Sector Antenna. Secure the Antenna with the bracket locking

nuts.

STEP 7. Attach and secure the Azimuth Adjustment Rod and Adjuster Clamp to the base of the

mounting bracket and the Azimuth Adjust Hole on the Collar Assembly. The clevis pin

on the adjusting bolt seats into the azimuth adjust hole on the top side of the Collar

Assembly (refer to Figure 6-5). No cotter pin is required for the clevis.

Figure 6-5 - Azimuth Adjustment Rod

STEP 8. The final assembly will look similar to the picture beow. Both azimuth and elevation

may be adjusted from the back side of the antenna with this configuration (refer to Fig-

ure 6-6).

Adjuster

Bolt

Adjuster

Clamp

Azimuth

Collar

Assembly

Clevis

Hole

Adjust