Operation Manual

November 1999
M68333 Rev. A Tel-Link PMP - Sector Terminal Installation & Maintenance Manual 6-3
Figure 6-2 - Antenna Mount Assembly
NOTE: If installing a 38 GHz system proceed to Step 5
STEP 4. The Antenna Feedhorns are attached to the Antenna Mount Assembly by two bolts
each. Transmit and Receive Feedhorns are attached to the ODU waveguides beneath
the protective cover (refer to Figure 6-3). Use Mylar tape and protective plastic caps to
protect the waveguide orifices to minimize contaminants in the waveguide. Proceed to
Step 6.
Figure 6-3 - Tx and Rx Antenna Feedhorns
Pole Adaptor
Assembly
Backplate
Pivot
Assembly
Antenna
Mount
Assembly
Protection
Cap for
Waveguide
Elevation
Adjusting
Knob
Antenna
Feedhorns
Antenna Mount
Assembly
Tx and Rx
Waveguides