INSTRUCTION MANUAL AND WARRANTY Copyright 2014, Ozeri Downloaded from www.Manualslib.
GENERAL SAFETY Thank you for purchasing the Ozeri Dual Zone Ceramic Heater and Fan. This product has passed extensive quality assurance tests for residential use. Every care has been taken to ensure that it reaches you in perfect condition.
• The base must be fitted securely before operating. Do not dismantle or use without the base fitted. • Suitable for dry locations ONLY. Do not use outdoors or on wet surfaces. Do not use in bathrooms, laundry areas and similar indoor locations. Never locate the heater where it may fall into a bath or other water container. Do not use or store where it may get wet or in the immediate surroundings of a bath, a shower or a swimming pool. • A heater has hot parts inside.
IMPORTANT SAFETY FEATURES For your safety this heater is fitted with automatic cut-out switches that operate if the heater tips over or overheats. If the switches operate, unplug the heater and allow it to cool. Before restarting the heater check and clear any blockages and ensure the heater is on a solid level surface. It is normal for the plug to feel warm to the touch; however, if there is a loose fit between the plug and the outlet or the plug becomes very hot, the outlet may need to be replaced.
8. Touch-button control panel with illuminating LCD and temperature display. 9. Extended range remote control. 10.76° oscillation with a programmable 12 hour timer (for both heater and fan functions). 11.Low and high speed settings (for both heater and fan functions). 12.Automatic overheat protection for both heating elements. 13.Automatic tip-over safety switch. 14.Dismountable dustproof filters allow for easy cleaning. 15.Easy-carry recessed handle. 16.Height of 85 cm / 33.5 inches.
Unpack the heater and check that you have main heater, the glass base, and remote control unit. Place the main heater flat on the ground (laying on its side) and remove the locking nut from the bottom end. Connect the glass base onto the bottom, and secure together with the locking nut. Note: Ensure the locking nut is firmly secured before standing the heater up on its base. REPLACING BATTERY 3 Your remote control is powered by an included CR2032 Lithium battery.
The following indicator icons will illuminate immediately above the control panel’s touch buttons. The indicators icons will activate based on the settings you choose via the touch buttons. Indicator Icon Overview: Indicator Icon Functions: 7 Downloaded from www.Manualslib.
Using the control panel’s buttons, press Heater (1) to turn on the top heater, and Heater (2) to turn on the bottom heater. Continue to press each to cycle through each heater’s off, low and high settings. The following icons will appear: Indicates the heater will release air at the low speed setting. Indicates the heater will release air at the high speed setting. To activate the heater’s thermostat, press the Temp/Timer icon: The room temperature display will flash on the screen.
The device can also be controlled via the included remote control. The remote control has 7 buttons that perform the same function as the main control panel. When using the remote control, point it towards to the control panel in the middle of the heater. MAINTENANCE This devices features 2 removable air filters. The air filters are designed to capture dust and airborne dirt, and should be inspected and cleaned once a month, or as needed on a periodic basis.
WARRANTY INFORMATION Your Ozeri product is warranted to the original owner for 1 year from the date of purchase against defects in material and workmanship under normal use and service. Should your Ozeri product prove defective within 1 year from the date of purchase, return the defective product, freight prepaid along with your receipt and an explanation of the claim to “Ozeri.” Please pack your Ozeri product carefully to avoid damages in transit.
