User Manual

ASSEMBLY INSTRUCTIONS

MODEL NO W965 - Sunshade

IMPORTANT: WE ADVISE YOU TO ASSEMBLE THE SHADE CANOPY ONCE

BEFORE USE TO BECOME FAMILIAR WITH THE ASSEMBLY

NOTE: PLEASE LOOK AT THE REPLACEMENT PARTS DIAGRAM TO SEE HOW

YOUR FRAME IS ASSEMBLED.

STEP 1: Spread shade out flat with

the pole sleeves facing up.

Shade should

appear as shown.

STEP 6: Stake down the shade by inserting stakes

through the loops at each corner of the tent, by the

hammering stakes into ground at a 45° angle,

making sure the floor is pulled out even and snug.

STEP 7: Guy ropes have been provided for the shade.

Extend each of the guy ropes and make a loop at the

opposite end by using the slider (as shown). Place the

loop over a stake and stake to the ground. Adjust the

slider to make guy rope tight.

NOTE: Sandbags are provided for use at the beach. Fill the bags with sand to

hold the canopy in place.

STEP 2:

Extend each of the fiberglass frame poles by pulling out each section and

placing pole ends into the metal ferrule connectors. You will have 2 fiberglass poles.

STEP 3:

Find the end of the pole with the

plastic cap and slide it all the way into the

grey pole sleeve until it stops at the end.

Repeat with the second pole. Position the

poles so that they form an “X” at the top of

the shade.

STEP 4: To raise the canopy, one person should go to each

of the back corners and flex the fiberglass poles into an upward

position forming two arches. Place the metal ferrules at the ends

of the poles into the fast feet at the base of the shade.

STEP 5: Unfold the floor and connect the hooks at each

corner to each corner of the shade.

STEP 8: Attach the removable shade wall(s) to

the shade as needed by connecting the hooks

at the corners to the fabric loops inside the shade.

NOTE: To take down the shade, follow steps above in the reverse order. Place

stakes into stake bag and poles into pole bag, which are provided. Make sure

shade is clean and dry before storing. The shade should be folded into equal

parts toward the center to distribute the bulk. Start a small tight roll, the width of

your carry bag. Once rolled, tie a string or rope around the shade to hold it in

place. Place shade and stake bag into carry bag.