User Manual

ASSEMBLY INSTRUCTIONS
MODEL W796.1, 96”x 48” 1 Person Hiker Tent
IMPORTANT: WE ADVISE YOU TO ASSEMBLE THE TENT ONCE BEFORE
GOING CAMPING TO BECOME FAMILIAR WITH THE ASSEMBLY OF THE TENT.
NOTE: PLEASE LOOK AT THE REPLACEMENT PARTS DIAGRAM TO SEE HOW
YOUR FRAME IS ASSEMBLED.
TO PROLONG THE LIFE OF THE TENT FLOOR, SELECT A LEVEL, CLEAN AREA
FOR THE CAMPSITE. TO PREVENT DAMAGE TO THE ZIPPER, UNZIP THE
DOOR TO ALLOW AIR TO ENTER THE TENT.
STEP 1: Spread tent out flat, floor side down, and stake the
four corners.
Top View
NOTE: To take down tent, follow steps above in the reverse order. Be sure
to leave door unzipped. Place stakes into stake bag and poles into pole bag,
which are provided. The tent should be folded into equal parts toward the
center to distribute the bulk. Start a small tight roll, the width of your carry
bag, with the pole bag placed at the end opposite the doors. Roll tent
toward doors to allow air to escape. Once rolled, secure with strings or
rope and place into carry bag. MAKE SURE TENT IS CLEAN AND DRY
BEFORE STORING
STEP 3: Insert the longest pole (A) into the pole sleeve over the door. Insert
the shortest pole (B) into the sleeve over the rear vent of the tent. Position poles
so that equal pole lengths extend on each end of the pole sleeves.
STEP 2: Extend fiberglass frame poles by pulling out each section and
placing ends into the metal ferrule connectors.
STEP 4: Flex the tent poles into an arch and place the ferrules
on the pole ends over the metal pins at the tent corners.
STEP 5: Extend the guy lines attached to the front
awning, over the door. Make a loop at the opposite
end of the guy ropes by using slider, as shown, and
place loops over tent stakes. Stake to the ground and
adjust sliders to make guy lines tight.
Tent should appear as shown.
STEP 7: After all guy ropes are staked, the tent should be completely upright.
Using sliders, adjust the guy ropes to make sure the tent roof is stretched tight.
STEP 6: Extend the webbing strap attached to the
rear awning and stake to the ground.
Tent should appear as shown.
TO IMPROVE THE WEATHER RESISTANCE OF YOUR TENT, IT IS ADVISABLE
TO USE SEAM SEALER TO COAT ALL EXPOSED SEAMS. YOU SHOULD APPLY
ONLY TO THE INSIDE SEAMS OF THE TENT. IF APPLIED TO THE OUTSIDE
OF SEAMS, DISCOLORATION OF YOUR TENT MAY OCCUR.
A B