User Manual

ASSEMBLY INSTRUCTIONS
MODEL W790, 11’8”x 11’8” 7 Person Teepee Tent
IMPORTANT: WE ADVISE YOU TO ASSEMBLE THE TENT ONCE BEFORE
GOING CAMPING TO BECOME FAMILIAR WITH THE ASSEMBLY OF THE TENT.
NOTE: PLEASE LOOK AT THE REPLACEMENT PARTS DIAGRAM TO SEE HOW
YOUR FRAME IS ASSEMBLED.
TO PROLONG THE LIFE OF THE TENT FLOOR, SELECT A LEVEL, CLEAN AREA
FOR THE CAMPSITE. TO PREVENT DAMAGE TO THE ZIPPER, UNZIP THE
DOORS TO ALLOW AIR TO ENTER THE TENT.
STEP 1: Spread tent out flat, floor side down. Unzip door to allow air to enter
the tent.
Top View
NOTE: To take down tent, follow steps above in the reverse order. Be sure to
leave doors unzipped.
MAKE SURE TENT IS CLEAN AND DRY BEFORE
STORING
. Place stakes into stake bag and poles into pole bag, which are
provided. The tent should be folded into equal parts toward the center to
distribute the bulk. Start a small tight roll, the width of your carry bag, with
the pole bag placed at the end opposite the doors.Roll tent toward doors to
allow air to escape. Once rolled, secure with strings or rope, and place into
carry bag.
STEP 3: Extend each of the steel poles by pulling out each wire-corded section
and placing the jointed ends into the connected pole sections. The Primary pole
will have a “Y” at one end (A) and the secondary pole (B) is straight.
STEP 2: Stake tent to the ground by inserting metal stakes
through the stake loops located at the six corners. Hammer
stakes into ground at a 45° angle and pull tent floor out even
and snug. Continue to stake down all intermediate stake loops.
STEP 4: One adult should enter the tent and lift the roof and tent up off the
ground. Another adult should enter with the two poles. The pole with the “Y”
(A) should be placed into the center of the roof with the “Y” at the top and the
extendable end on the tent floor at the side corner between the 2 windows.
STEP 5: The secondary pole (B) should be inserted into the bottom of the “Y”
with the extendable end on the tent floor at the opposite side of the tent from
the primary pole.
Tent should appear as shown.
STEP 8: Guy ropes have been provided for the windows.
Unzip the windows and extend the guy ropes. Make a loop
at the end of guy ropes by using slider (as shown) and
place loop over tent stake. Hammer stake into ground
at a 45° angle. Adjust slider to make guy rope snug.
Repeat with the remaining guy ropes. Release the guy
ropes to close the windows in inclement weather.
STEP 6: Extend the poles at the bottom until the spring pin snaps into the first
hole. Adjust tension to the second hole as needed to keep tension on the tent.
STEP 7: Secure the tent to the poles by wrapping the hook and
loop fasteners around both poles.
The tent should appear as shown.
A
B