User Manual

ManualsBrandsOzark Trail ManualsOzark Trail Sports & Outdoors1-Person Backpacking Tent with Aluminum Poles & Vestibule

ASSEMBLY INSTRUCTIONS

MODEL W785.1, 87”x 34” 1P Backpacking Tent w/vestibule

IMPORTANT: WE ADVISE YOU TO ASSEMBLE THE TENT ONCE BEFORE

GOING CAMPING TO BECOME FAMILIAR WITH THE ASSEMBLY OF THE TENT.

NOTE:

PLEASE LOOK AT THE REPLACEMENT PARTS DIAGRAM TO SEE HOW

YOUR FRAME IS ASSEMBLED.

TO PROLONG THE LIFE OF THE TENT FLOOR, SELECT A LEVEL, CLEAN AREA

FOR THE CAMPSITE. TO PREVENT DAMAGE TO THE ZIPPER, UNZIP THE

DOORS TO ALLOW AIR TO ENTER THE TENT.

STEP 1:

Spread tent out flat, floor side down.

Top View

NOTE: Make sure tent is clean and dry before storing. To take down

tent, follow steps above in the reverse order. Place

stakes into stake bag and

poles into pole bag, which are provided. The tent

should be folded into equal

parts toward the center of the tent to distribute the bulk. Fold fly and lay on top

of tent. Start a small tight roll, the width of

the carry bag, with the pole bag

placed at one end. Roll the tent tightly allowing air to escape. Once rolled, tie

a string or rope around tent to hold into place. Place tent, frame and stakes into

carry bag.

STEP 3: Insert the pole tips into the grommets at the back

corners of the tent for each pole. From the front corners,

flex the pole and insert the tip into the corresponding

grommets. (Inner grommets will provide a tauter set up)

STEP 2:

Extend the frame poles by pulling out each section and placing ends

into the connectors.

STEP 4:

Starting at the top of the tent and working downward,

attach all the clips to the poles.

Tent should appear as shown.

STEP 6:

Unfold the fly and place it over the tent. Use the

color-coded webbing to align the fly with the inner tent.

STEP 5:

Stake down the tent by inserting stakes through the

stake loops at each corner of the tent. Hammer the stakes

into the ground at a 45° angle. Pull the out even and taut.

If it is windy, the tent can be staked down as part of STEP 1.

Assembled tent should appear as shown

STEP 7:

Fasten the hook and loop fasteners sewn to the

fly around the tent poles.

STEP 8:

Attach the fly to the tent by hooking the

grommets over the bottom of the pole tips.

STEP 9:

Stake down the front vestibule and back of the fly by inserting a stake

through the webbing loops. Be sure to pull the vestibules out even and taut.

STEP 10: Guy ropes have been provided for added

stability. Extend each of the guy ropes and make a loop

at the opposite end by using the slider (as shown). Place

the loop over a tent stake and stake to the ground. Adjust

the slider to make guy rope tight.