User Manual

FULLY EXTEND FRAME
as shown in Figures 1, 2 and 3; then flip extended frame over to upright position.
SET UP BED FRAME
Before you begin
Read all instructions thoroughly before beginning set up.
• Select a level site clear of rocks, branches and other hard or sharp objects before
setting up bed frame.
• Carefully read all warning tags and TO OPEN /CLOSE VALVE tag on air mattress.
• Two people can easily setup this bed with air mattress in minutes.
Figure 1
Figure 2 Figure 3
INSTALL OR CHANGE BATTERIES
• Unhook latch and open lid to battery compart-
ment. (Fig. 4 and 5)
• Insert four D-cell batteries as shown. (Fig. 5)
• Close lid and hook latch to secure.
AIR MATTRESS PUMP
Figure 5
Figure 4
INFLATE AIR MATTRESS IN COVER
• Unfold the mattress and flatten all edges.
• Put air mattress inside cover
• Pull valve cap on mattress to open. (Fig. 6)
NOTE: Insert black one-way valve before filling.
• Place medium diameter nozzle onto “INFLATE”
labeled outlet of air pump. (Fig. 7)
• Insert filling nozzle into fully opened valve.
• Switch on air pump and fill mattress to
desired firmness. DO NOT OVERFILL.
• Turn off switch, remove air pump and im-
mediately insert valve cap.
Figure 6 Figure 7
Switch
Medium Filling Nozzle
Valve
INFLATE AIR MATTRESS IN COVER (continued)
NOTE: Make sure air valve on mattress is posi-
tioned at the open zippered end of mattress cover.
(Fig. 8)
IMPORTANT: Fasteners are located on the bottom
side of the cover.
• Zip up mattress cover completely.
ATTACH AIR MATTRESS
Figure 8
Cover
Valve
ATTACH MATTRESS TO TOP OF FRAME
• Align fasteners located on bottom of the mattress
cover and top of the bed frame. (Fig. 9)
• Press down firmly on top of mattress at each
corner to secure.
Figure 9
• Remove mattress from frame.
STORING AIR MATTRESS, FRAME & PUMP
DEFLATE AIR MATTRESS
• Unzip mattress cover to access valve cap.
• Pull valve cap to open and pull out the one-way black
valve. (Fig. 10)
NOTE: This will allow air to escape and start deflating
the mattress.
• Place medium diameter nozzle onto “DEFLATE”
labeled outlet on top of the air pump. (Fig. 10)
• Insert filling attachment into fully opened valve.
• Turn on air pump switch and remove air until mattress
is completely flattened.
• Remove mattress cover then fold to store.
• Fold the mattress to store.
Figure 10
Switch
FOLD UP FRAME
• Flip extended frame over to as shown in Figure 3.
• Fold up legs in reverse order (Figures 2 and 1)
• Place the frame, mattress and cover in carry case.
• Remove batteries from air pump and place in carry case.