Product Manual
EN pg.5
Safety Warnings
Failure to read and comply with the following warnings may result in a hazardous situation that
could lead to death, serious injury, or property damage. Keep this manual near the equipment at
all times. Do not remove, alter, or obscure the labels attached to the winch. Contact OZ Lifting
Products LLC
®
for replacement manuals and labels.
Do Not operate a damaged or malfunctioning product.
Do Not operate if guards are improperly installed or removed.
Do Not lift more than the rated load of the crane or its attached components.
NOTE: Under a severe overload condition, an audible cracking sound from the crane may be heard. This
is cause for an immediate removal of the load from the crane, inspection of all components, and possible
crane replacement.
Do Not use additional cranes to move a load that is heavier than the load rating of any single
crane in use.
Do Not modify this product in any way.
Do Not use for other functions except those for which this product is intended.
Do Not remove, deface, or obscure warning labels.
Do Not allow load to swing or jerk. Operate smoothly to avoid shock loads.
Do Not lift any load that is not located directly below the crane. This product is not intended to drag
a load sideways.
Do Not wrap the load with the wire rope. Use only a sling or another manufacturer-approved device.
Do Not operate without 4 anchor wraps (8 anchor wraps for Dyneema based synthetic cables) of wire
rope around the winch drum.
Do Not operate without assuring wire rope is securely attached to the winch drum.
Do Not operate without checking for proper lubrication.
Do Not put hands in areas with moving parts such as sheaves, wire ropes, and gears.
Do Not lift people.
Do Not lift loads over people.
Do Not operate until personnel are warned of approaching loads and are cleared from the area.
Do Not leave a suspended load unattended.
Do Not substitute smaller diameter pins. Use only the pins supplied with the crane.
Do Not operate or store the crane in an environment that exceeds 120 degrees Fahrenheit.
Do Not use chains, cables, or rigid devices to lift crane. Nylon or other synthetic slings should be
used instead.