Product Manual

Inspection
In order to maintain quality operation of the product, a regular inspection schedule should be followed by
each operator. All inspections should be reported and maintained in a dated record log located at the end
of this manual. You will notice that the rst entry has been made as the trolley passed an inspection prior to
leaving OZ Lifting Products headquarters. These records should be available to all personnel involved with
the product and should be made available to OZ Lifting Products LLC® when a warranty issue is in question.
Operators should inspect trolley before each usage. Each trolley must pass an inspection by a qualied
person every six months to remain in service. Inspect for wear, damage, cuts, cracks, corrosion, impact
damage, pits, burrs, rough surfaces, sharp edges, rust, paint build-up, excessive heating, alteration, and
missing or illegible labels. During any inspection, also test that the trolley functions smoothly and that the
spindle threads are in good condition. If any problems are observed, the trolley should be placed out of
service until it can be repaired. Use only OZ Lifting Products LLC® for replacement parts. The trolley should
be taken annually to an authorized repair center for professional inspection.
Worker Classications
Designated Person - The person who is selected or assigned as being competent to perform specic duties.
Qualied Person - The person that—by possession of a recognized degree or certicate of professional
standing, or through extensive knowledge, training, and experience—has successfully demonstrated they
are able to resolve problems relating to the subject matter and work.
Safety Warnings
Push Beam Trolley (Personal Fall Protection Usage)
Do Not use any trolley that has not passed inspection by a qualied person within the past six months.
Do Not alter or misuse equipment.
Do Not use in a non-compliant manner.
Do Not operate in a workplace that has not been assessed for proper use.
Do Not purchase used personal fall arrest systems.
Do Not use non-compliant harnesses and connectors.
Do Not operate without a rescue procedure in place.
Do Not use to hang, lift, support, or to hoist tools or equipment.
Do Not use without records of proper inspection.
Do Not use trolley as an anchor point for more than one personal fall arrest system.
Push Beam Trolley (Material Handling Usage)
Do Not lift more than the designated load range.
Do Not lift people or lift loads over people.
Do Not operate a damaged or malfunctioning product.
Do Not remove, deface, or cover warning labels.
Do Not operate until personnel are warned and cleared from the area.
Do Not use if load is not suspended vertically.
Do Not use trolley without locking rmly in place.
Do Not use trolley as a welding ground.
Do Not add lengthening pieces to the beam clamp lever.
Do Not weld on the lifted load.
Do Not open the trolley when it is holding a load.
Do Not use trolley in corrosive environments.
Do Not use connections between the trolley and load.
Do Not allow the load to swing.
WARNING: Failure to read
and comply with these safety
warnings may result in a
hazardous situation that could
lead to death, serious injury, or
property damage.
EN pg.8