Operation Manual

30
Problem indication
Problems can occur during the operation of the automatic antenna unit if e.g. the
freedom of movement of the antenna is not guaranteed (branches, snow, etc.).
The type of interference will be automatically recognised and presented on the external
indication as a fault code.
Display Fault description Interference elimination
E 01 No satellite signal could
be found.
Change your location. Do you have a free view
to the North? Are you in the receiving area of
a satellite?
E 02
E 03
Dish blocked in the
rotation direction /
elevation direction
Is an object projecting into the movement area
of the antenna? Is the supply voltage too low
(weak battery)? Switch the equipment off with
the MUTE button (hold down for 3 seconds)
and then switch on again.
E 04 Dish cannot completely
retract and switch off
Press EXIT to close the antenna again.
Remove snow, leaves or other objects from
the storage hollow in the antenna body.
E 05
E 06
Top box does not
respond after the switch-
on or does not react to
commands
Is the red (10Amp.) fuse OK? Are all the
cables correctly inserted?
E 07 Short-circuit in the
antenna cable or LNB
Check the white antenna cable and the plug.
E 08 No or low voltage for
the top box
Check the fuses on the rear side of your
receiver.
E 09 No LNB connected or
LNB out of order
Insure that the white IF lead is properly
connected to the receiver, the top box and the
LNB. In rare cases your LNB might by faulty
as well.
E10, 11, 12 Voltage drops occur
while dish is moving
You should charge up your battery ASAP.
This is a warning only.
E 15 Faulty response from
top box
The interconnection from decoder to top box
could be weak and should be checked.
E 16 Model configuration
fault
The internal configuration of your decoder
does not match to Australian conditions.
Contact your dealer for assistance.
E 17 Re-initialisation
performed
One or more memory errors have been fixed
automatically. Please restart your decoder.
E 99 Buffer overflow Switch the main switch to OFF, wait for 10sec
and switch ON again to restart the decoder