Operation Manual

Operation with additional satellite receiver

If you wish to operate an additional satellite receiver on the same antenna as the Digital

receiver, connect the signal from the IF-OUTPUT of the Digital receiver to the antenna

input of the second receiver.

So that this procedure functions correctly, only one of the two receivers may control the

LNB voltage of the antenna. In order to ensure this, the unused equipment should be

switched off. It is sufficient to put the Digital receiver into the standby mode.

So that the automatic satellite finding of the Oyster Digital can function without

problem, during the search no interruption of the signal is to take place. Therefore the

second receiver must be switched off during the fully automatics search or the local

search.

Please note, that you cannot receive with both receivers at the same time - should you

require this, the option “Twin-LNB” is recommended. In this case a special LNB

(receiver head) with two outputs is mounted in the Oyster external unit and two antenna

cables will be used.