Operation Manual

Preparation of the channel list

You can change the channel list of the receiver in accordance with your own ideas. We

highly recommend that the channels are grouped according to satellites, as they are in the

pre-installed channel list.

Call up the channel list editor through the menu point “Channel list / Sort channels” in

the main menu.

Once you have completed the required changes, leave at the transmitter list with EXIT.

Confirm the subsequent question with OK in order to store the channel list.

To discard any modifications you have made confirm with SWAP.

In order to change an entry, you must select an entry in the list, then press OK. Then

appears a menu with the available functions.

If you want to work on a complete block of one after other channels, select the option

“Block marking” in the menu. In this case the menu disappears and you will be required

to mark the end of the block in the list. Go to the last entry which belongs to the block

and press OK. Then the menu with the available options will be inserted.

The following are functions are available in the menu:

Copy Copy the transmitter in another position of the transmitter list. The

target entry will be deleted.

Move Move the entry to another position.

Note: if you move an entry upwards, it will appear in front of the

target entry. If you move it downwards, it will appear behind the

target entry.

Delete Deletes a transmitter from the transmitter list. The entry will be

marked in the list as unused. This leaves the numbering of the other

transmitters unchanged.

Cut out Deletes a transmitter from the transmitter list. The following

transmitter returns to the vacated position.

Note: In order to maintain the blocking of the transmitters all the

transmitters only return to the next entry marked “unused”. If the

list of entries from 85 to 99 are not occupied, you can for example

delete entry 57 and only return transmitters 57 to 84. The

transmitters from 100 remain unchanged.

Free

insertion

Only inserts an empty entry. The following transmitters return

correspondingly to the rear.

Note: As with “Cut out” this operation sends all the transmitters

marked “unused” to the end of the block.

Packing This option is only available, if you have marked a block. Within this

block all the gaps with entries marked “unused” will be moved as

transmitters are inserted above. The empty entries are then to be

found gathered together at the end of the block.

With the functions concerned with a target entry, following the selection of any menu

point, you will be required to select the target entry. You do this, by going to the entry in

the list and confirming with OK. Providing you have not completed a function, you can

return to the previous step with the EXIT button.