Operation Manual

12
Basic settings
Following the first switch-on, some adjustments should be made in the operating
software. Please carry out the following steps:
1. Call up the main menu. 2 x MENU
2. Select the “Edit settings” menu and then the sub point
“General”
P+/P-
OK
3. Input your current time zone.
For Queensland: +10:00
For Southern Australia and Northern Territories: +09:00
For Western Australia: +08:00
This setting must be updated each time following the summer time
change, if applicable.
You can change the setting either with the arrow buttons or
through the direct inputting of the numbers.
0 –9
+/-
4. Leave the general adjustments with EXIT.
5. Go to the topic “Save settings”. Press OK and wait until the
menu disappears.
P+/P-
OK
All further configuration facilities will be explained detailed on page 18 in the section
“Configuration of the receiver”.