Operation Manual

54
Fault codes
Malfunctions of the automatic antenna unit may occur e. g. when the
antenna's motion is obstructed by branches or snow.
Such malfunctions are automatically detected and will be displayed by the
satellite mouse as fault codes.
Code Malfunction Remedial action
E 01 The search did not yield
the reception of a satellite.
Change your location. Do you have a
clear view to the South? Are you
within the 'footprint' (range) of a
satellite?
E 02
E 03
Antenna rotation (E02) or
elevation (E03) motion is
blocked.
Is the motion obstructed by
obstacles? Is the supply voltage
insufficient (weak battery)?
E 04 Antenna does not fully
retract and switch off.
Press EXIT to re-open the antenna.
Remove snow, leaves or other items
from the antenna. DO NOT switch
off the system by setting the master
switch to OFF before having
eliminated the cause of the
malfunction.
E 05
E 06
Antenna does not react
after activation or does
not react to commands.
Is the red fuse (10 A) at the receiver
i
n order? Are all cables correctly
connected?
Contacts of the control cable may be
slightly oxidized. Disconnect and
reconnect the cable.
E 07
E 09
Short-circuit/open circuit
in antenna cable or at
antenna.
Check the white antenna cable and
the connectors at the receiver and at
the LNB.
E 08 No or insufficient voltage
for antenna unit.
Check fuses on the rear of the
receiver.