Operation Manual

Note that all satellites can be received as long as you do not

change any settings. If you change any of the settings, the

reception unlisted satellites will be suppressed.

The channel list will be updated as required when new satellites are

installed in orbit. This list can be downloaded from the Internet and

uploaded into the receiver by a computer. (see page 56).

Updated lists are available for download at www.ten-haaft.de/forum

Edit Settings Æ Signal Output

TV Screen:

Here you can adjust your system to wide-screen television

sets with a 16:9 aspect ratio. For mobile applications, sets with a 4:3

aspect ratio are primarily used.

RGB /YUV: This option allows the selection of the YUV composite

signal as an alternative to the default RGB signal. The RGB or YUV

signal is supplied to the SCART port and also to the correspondingly

identified coloured Cinch jacks. Please refer to the operating manual of

your TV set to determine which signal type is supported. The signal of

the CVBS and Y/C ports and the FBAS signal at the SCART port are

not affected by this setting.

Volume Bypass: This menu item deactivates the volume control. With

the default setting "Off", the volume of the television set can be adjusted

with the digital CI receiver's remote control.

Digital Audio: Here, you can select which digital audio formats are

output via the SPDIF port. Please only select formats that are

compatible with the audio devices connected. The selection of the audio

format output to this port depends on the formats transmitted by the

stations (e.g. Dolby 5.1). The desired audio channel can then be selected

via the sub-channel selection (see page 21).