Operation Manual

17
Channel selection
The receiver maintains an internal channel list. This list contains all
channels of the activated satellites. The channels of deactivated satellites
are not displayed.
There are several alternatives for selecting channels:
P+ / P–
/
Change to the previous or next channel in the channel list
TV
RADIO
Change between TV and radio mode.
SWAP Switch between current channel and the previous channel.
The software stores as previous channel the channel that
was last active for more than one second. You can
therefore scroll through the list by quickly pressing P+ or
P–. The channels only activated briefly in the process will
not be stored by the SWAP function.
0 – 9 You can also select channels by pressing the number keys.
In this case, you can shorten the input by pressing OK (if
the channel number has just one digit) or cancel the input
by pressing EXIT.
To enter a number with less than four digits, you can
complete the input by holding the key of the last number
down.
Note: By directly typing in numbers you can also select
deactivated channels (see page 34).
Do not start the direct entry of channel number with the
number "0" as this will open the favourite channels list.