Oxy 3 2018 Tareq Edition Manual

Important Note:
This part comes pre assembled
WITHOUT thread lock. Follow
the instruction for final assembly
Once you finish assembly, ensure the DFC
Arms can rotate without friction. If the DFC
Arms are assembled correctly, rotation
should be smooth and without friction. In
case of any friction, recheck each
component and re-assembly as necessary.
Swash Plate Assembly
( Box1/Bag18 )
Important Note:
this part, for tuning reasions,
comes factory pre assembled,
it ready to use.
OXY0020-M1.2x2
Special Screw
Center Ball
Lower and Upper
Swash Plate
OXY0018-2x
11.5 Anti Rotation Pin
OXY0043 -
Linkage Ball
OXY0019 -
Swash Plate Ball
Important Note:
This part comes pre assembled WITHOUT
thread lock. Follow the instruction for final
assembly.
Swivel Ball Note:
The Swivel Ball is pre-assembled with a
precise fitting. When new, the Swash Plate
center ball will have a little friction. After a
few flights and “break-in” it will come smooth,
keeping the best precision without play.
TCEM2X20-
M2X20 Hex Cap Screw
OXY0757-
Main Grip Bushing
OXY0904
M2 Custom Nut
DFC Arm
Page 25
Chapter 11: Main Rotor Assembly