Install Instructions
Installer’s Guide
Installation Instructions:
1. The blanking strip is made with two sections in order to fit
all cabinet sizes.
2. Combine the two sections in order to properly fit the
appropriate cabinet size. The screw locations are shown
as per figure below.
Screw (X 3)
Screw (X 3)
Screw (X 2)
Align holes in the two sections
3. Using #8 screws, attach the blanking strip to the coil and
furnace. Seal as needed and per local code to ensure an
airtight fit.
Back of Coil
Back of Furnace
Trane
6200 Troup Highway
Tyler, TX 75707
For more information contact
your local dealer (distributor)
Since the manufacturer has a policy of continuous product and product data improvement, it reserves the
right to change design and specications without notice.
© 2020 Trane. All rights reserved.
Literature Number 18-CH103D1-1A-EN
Superceded Literature Number New
02/20