Operation Manual

3. OPERATING THE OXBOARD AND SPECIAL FUNCTIONS
3.1 Remote control
The Oxboard is supplied with a re-
mote control. Please keep this in a
safe place even if you do not use it
every day. The remote control will
react up to a maximum distance
of five metres whereby you can
switch o, (un)lock or balance your
Oxboard (see 2.4). Note: The first
generations Oxboard had dierent
remote with 2 buttons (lock/unlock)
3.1.1 Power
You can turn the power o by pressing Button 1
on the remote. A sound ( short beep) will confirm
its o. The battery indication light will go out.
You can switch Oxboard on using button 1+2.
After 1 hour the Oxboard will switch of automatically
so you can only switch on using the power button
on the remote.
3.1.2 Switch sensitivity mode
There are two settings to control the maximum
power/speed of an Oxboard. A low sensitive learning
mode vs. high sensitive experienced mode.
Turn on the Oxboard by pushing the power button
(you’ll hear a long beep). Push button 4 until the
short beep. Push power button to switch
Oxboard o.
Speed warning: Over 10 Km/h the Oxboard
will start bleeping.
Without a remote the steps are:
Turn on the Oxboard by pushing the power button
(you’ll hear a long beep); push power button for
second time within 2 seconds. A short beep will
confirm the adjustment. Push power button to
switch the Oxboard o.
3.1.3 Calibrating the balance of the Oxboard
The Oxboard may feel unbalanced after some
time or following harsh treatment: the Oxboard then
feels as though it is shaking or waddling when riding.
This can be solved by balancing the Oxboard.
This is done as follows:
1. Push power button on the Oxboard to switch on.
2. Level the Oxboard (foot pads parallel and
horizontal to the ground).
3. Press and Hold button 1 + 2 together. Hold until next
beep (2-3 secs). After the beep release the button.
Front and backlights start flashing and the current
profile is loaded successfully.
4. Push power button on the Oxboard to save
and to switch the Oxboard o.
Without a remote the steps are:
Level the Oxboard (foot pads parallel and horizontal
to the ground). Press and hold power button.
First you’ll hear an activation sound. Hold until next beep
(2-3 secs). After the beep release the button.
Front and backlights start flashing and the current
profile is loaded successfully.
Push power button to save and to switch the Oxboard o
(short beep will confirm it’s o).
INSTRUCTIONSINSTRUCTIONS
1110